How to Install a Toilet Paper Holder?

Adhesive toilet paper holder will fall down easily in the humid bathroom.

In this case, you may need a wall mounted toilet paper holder.

Yumore wall mounted toilet paper holder is very easy to install.

Here are the accessories for a new toilet paper holder:

2pcs of wall anchor &2pcs of screws & 1pc of hexagon wrench

Here is the Installation Procedure:

Step 1

Choose a right spot for the toilet paper holder, so you can reach the toilet paper easily.

Usually 8 to 12 inches in front of the toilet and 26 inches above the floor.

Step 2

Loosen the screw on the mounting base of the roller holders with the hexagon wrench like below picture:

The toilet paper holder usually look like this after loosening the screw on mounting base ( the toilet paper holder body and mounting base separated):

Step 3:

Measure the distance of the two holes on the base. Drill two holes at same distance on wall. 

Then put into the wall anchor. You may need to tap the anchors lightly with a hammer to get them to go in. 

When fully inserted, the front edge of each one should be flush with the wall.

Tip: If you're installing the paper holder on ceramic tiles, drill the holes with a masonry bit.

Step 4:

Screw the mounting base onto the wall anchors:

Step 5:

Attached the toilet paper holder body with the mounting base, fasten the screw again. 

Done!  Isn't this easy?